Maximum Sirocco Uživatelský manuál stáhnout pdf

SIROCCO

INSTALLATION

PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR

ELECTRICIAN OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY,

OR HARDWARE STORE FOR REFERRALS). TO PROMOTE CONFIDENCE, PERFORM A TRIAL

WIRING BEFORE INSTALLATION.

HOSE CLAMPS

TALL MAST

DRIP

LOOP

WIRE-HOLE

WIRE

SCREW

WALL

ANCHOR

(NOT SUPPLIED)

CAULK

WIRE

Determine where you are going to locate both the

rooftop sensor and the read-out.

Feed the terminal lug end of the 2-conductor cable through

the rubber boot and connect the lugs to the terminals on the bottom

of the wind speed sensor. (Do NOT adjust the nuts that are already

on the sensor). The polarity does not matter.

Slide the stub mast through the rubber boot and insert the stub mast

into the bottom of the wind speed sensor. Secure with the cotter pin.

Coat all conections with silicone sealant and slip the boot over the sensor.

Secure the sensor and the stub mast to your antenna

mast (not supplied) with the two hose clamps. Radio

Shack and similar stores have a selection of antenna

masts and roof mounting brackets. Choose a mount that best

suits your location and provides at least eight feet of vertical

clearance above objects on the roof.

Feed the cable through the wall to where the read-out is

going to be located. Attach the wires to the rear of the

read-out as shown. (Do NOT adjust the nuts that are

already on the meter). The polarity does not matter.

The Sirocco read-out is free standing. It can also be mounted

on a wall using the key hole cut outs in the back of the instrument's

wood block.

Secure the wire to the building using

cable clips (do not use regular staples).

Form a drip loop where wire enters hole

drilled through the exterior wall.

Caulk the hole when done.

Follow the instructions supplied with the antenna

mount and secure the mast to the mount.

CABLE

CLIPS

8 FEET

CHIMNEY

MOUNT

VENT-PIPE

MOUNT

TRIPOD

MOUNT

WALL

MOUNT

EVE

MOUNT

Samuel Barnett Boulevard

New Bedford, MA 02745

(508) 995-2200

2-CONDUCTOR

CABLE

BOOT

COTTER

STRAIGHT

STUB MAST

2-CONDUCTOR

CABLE

WIND SPEED

SENSOR

1 2 3 4

Shrnutí obsahu

Strany 1 - INSTALLATION

SIROCCOINSTALLATIONPROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR ELECTRICIAN OR TELEVISION ANTENNA INSTALLER (CHECK

Strany 2 - ADDITIONAL INFORMATION

SIROCCOOPERATIONTROUBLE SHOOTINGADDITIONAL INFORMATION 1. Disconnect the wires from the back of the read-out.

Strany 3

IMPORTANT ADDITIONAL INFORMATION Components: Along with the indicator, the following components are included with this instrument:

Strany 4

30 SAMUEL BARNET BOULEVARD  NEW BEDFORD, MASSACHUSETTS 02745 U.S.A. TEL. 508.995.2200  WWW.MAXIMUM-INC.COM  FAX 800.989.2580 Electrical Damage

Komentáře k této Příručce

Žádné komentáře

Maximum Sirocco Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Měřící nástroje Maximum Sirocco. Maximum Sirocco User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Měřící nástroje Maximum Sirocco